Lab Tour
What the Lab Actually Looks Like
A single-suite fitting lab on Bluebonnet Boulevard, built around one instrument rather than a showroom floor of demo bays.
The Beam Station
A certified reference weight sits beside the calibrated beam scale, checked against it before every session so every reading in the building traces back to the same standard, not a scale that drifted six months ago.
The Build Bench
Visible from the beam station through an open pass-through, not tucked in a back room — you can watch a shaft actually get pulled, weighed, and installed if a session runs into a same-day build.
The Component Wall
Heads and shafts organized by category, each tagged with its measured weight rather than just the manufacturer's stock spec sheet number.
A Single Suite, Not a Big-Box Floor
Suite E in a small strip off Bluebonnet Boulevard, a few doors down from a handful of other independent shops. Free lot parking sits directly outside — no separate entrance to hunt for.
Stop In Before You Book
Weekday afternoons are usually the quietest time to take a look at the setup with no obligation attached.